Use a cleaning cloth to clean the screen surface of the screen protective film with dust and oil stains (otherwise it may cause dust and foaming after posting).

1. The reticulated protective film uses a cleaning cloth to scrub the dust and oil on the surface of the UV lamp control power supply screen (otherwise it may cause dust and foaming after posting).

2. Put the poster side down, lay out the maintenance film about one-third, align it with the top edge of the screen, and slowly pull out the maintenance Iwata spray gun film while posting. The time of posting is as slow as possible and acknowledge the excellent attachment. , To prevent bubbles from occurring.

3. Finally, peel off the surface release film "2". If you find that small bubbles have been left accidentally, you can use a soft scratch card to flatten and push the bubbles away.

Application notes:

(1) Make sure that the LCD screen is free of dust before attaching the protective film.

(2) When sticking the protective film, your fingers should prevent touching the veneer of the film, avoid leaving dust on the veneer, and there will be bubbles when sticking.

(3) Ensure that it is pasted once, and the reticulated protective film avoids leaving dust when it is pasted again, and it will be airy after pasting.